What will happen when the car is filmed?
Generally, no matter how long the car is bought, the car will be regularly maintained, and the maintenance must not be filmed. For the film, you may not know that opening the window after the car film will affect the effect of the film. Everyone should pay attention to this later. However, some masters will remind you when you are in the repair shop. Today, Xiaobian will tell you what will happen when you open the window after the car is filmed . High-quality car film usually has good wear resistance. The special high-performance resin glue is used between the film layers. The adhesion is very outstanding. When the film is applied, the edge of the film and the edge of the glass are only 2 mm. Moreover, the anti-scratch coating makes it highly scratch-resistant and has a long life and is easy to maintain. On weekdays, the lift window is also easy to wear the film surface. Inferior film will be scratched after one or two months. Choosing a good quality film can avoid this situation. 1. How long does it take to open the window after the car is filmed? After the construction of the car foil, do not lift the window at will within 3 days in the summer and 7 days in the winter. The reason is that the glass has just been attached to the car film. The glass is usually tight. During the opening and closing of the window, the edge of the car film is easy to roll up and cause damage to the car film. After the car is finished with the film, it is within 3 days in the summer and less than 7 days in the winter. Do not lift the window at will. The main reason is that the car has just been attached to the automobile film. The glass is usually tight. During the opening and closing of the window, the edge of the car film is easy to be rolled up and curled, causing certain damage to the car film. 2. Precautions after car filming Within one week after car filming, when parking the vehicle, you should choose a sunny place to ensure that the water vapor in the car film is fully evaporated; it is strictly forbidden to wash the car within three days of the car film. This is to prevent the car film from falling off due to moisture, so When the car film is applied, the car can be washed and then filmed. The micro-water filming process of Weigu Auto Film can better ensure the effect of automobile film construction in addition to protecting the circuit panel of the car. 3. Cloudy water vapor appears after the car is filmed Due to weather and other reasons, the time required for the car to dry out after filming is different: in winter and rainy days, cloud-like water and gas may appear between the film surface and the glass, which is a normal phenomenon. After 4-10 weeks by the sun, it is natural. Dry out and disappear. 4, there are stains on the car foil If there is stain on the car foil, do not scratch it with a sharp hard object or use a irritating chemical solution. It is recommended to wipe it gently with a soft towel such as a clean wet towel, sponge or soft cloth. At the same time, avoid using corrosive chemical solvents when washing your car to avoid damage to the surface of the car foil. 5, can open the air conditioner after the car film After the front bumper film is applied, do not let the air conditioner blow forward directly in the 7 days. After the film is stuck in the rear gear, do not open the rear fogging line within one week. If the moisture is not dry, it will easily affect the defogging line. Be sure to turn off the wire after use to avoid the long-term high temperature causing the car foil to foam and deform. 6, how long after the car film can be sucked with a suction cup In order to ensure that the car film adheres firmly to the glass, do not directly affix or hang things on the window within two months after the car film is applied, so as not to open the gap when pulling up the suction cup and the sticker, or damage the car film. After the car film is opened, how will it be finished for everyone? The correct use can increase the life of the film, and it will not be scraped up just after it is finished. Still have to post. Under normal circumstances, everyone can pay attention to their own after filming. There are also notes on Xiaobian that everyone should pay attention to. I hope that the culture of Xiaobian is useful to everyone.
Throttle Position Sensor is also known as the throttle opening Sensor or throttle switch. Its main function is to detect that the engine is at idle speed condition or load conditions, the working condition to speed up or slow down.
The sensor is usually located on the butterfly spindle/shaft so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used, for example an extra closed throttle Position Sensor (CTPS) may be employed to indicate that the throttle is completely closed.
Throttle Position Sensor Throttle Position Sensor,Engine Position Sensor,Buick Throttle Position Sensor,Hyundai Throttle Position Sensor NINGBO DGOFEN AUTO TRADE CO., LTD , http://www.dgofen.com
