Electric and hydraulic combination injection molding machine came out in the world

March 26, 2021

Nissei Plastic Industry Co., Ltd. has introduced a new series of injection molding machines "FNX" that uses a pump system consisting of a servo motor and a hydraulic pressure in a driving source. This pump system is already available in the "PNX" series launched in September 2005. By using the motor only when needed, about 10% less power is consumed in the 1078kN older product. There are 4 models, "FNX80-9A / 12A" with clamping force of 784kN and "FNX110-18A / 25A" with 1078kN. In terms of selling price, FNX80-9A is 8.9 million yen and FNX110-18A is 10.5 million yen.

Injection preparation time is reduced to the same electrical 45ms. Injection speed can be set between 1 ~ 300mm / second. Due to the small flux losses, drive measurements are reduced by up to 41% compared to older hydraulic presses. And further improve the repeatability, so as to control the instability of the quality of formed products to the past 1/3.

For the clamping structure, and PNX series using the same direct clamping mode. It is characterized by the mold can be evenly transmitted to the mold force, long-term maintenance of parallelism. Support mold thickness mold. In addition, you can shorten the time to replace the mold.

1. High quality imported Compressor energy saving and low noise.Compressor brand Embraco and Danfoss is available for customers to choose.
2. Toughened heated glass, anti condensation and energy saving and good visual effect.
3. LED light in illumination, avoiding glaring.
4. Independent electronic board and cooling system, can be easily taken out for maintenance or replacement.
5. Environment-friendly CFC-free Refrigerant R134a or R404a.

Ice Cream Display Cabinet

Ice Cream Display Cabinet,Ice Cream Freezer,Ice Cream Display Freezer,Gelato Ice Cream Display Freezer

ShanDong XiMaiD Commercial electrical appliance Co. LTD , https://www.sdximaide.com