Energy-saving ball mill gear load reduction method

In addition to linings and steel balls, the gears of energy-saving ball mills are also subject to wear during long-term use. This cannot be avoided because the kinetic energy from the electric motor and the gearbox is transmitted via the pinion to the large gear. However, we can take some measures to reduce the gear load and thus reduce the loss.

In the event of a ball mill failure, Zhengzhou Hongtai (1352.6601.405) can be consulted at any time. Information on energy-saving ball mills can also be found on the Hongtai website.

The maintenance of the ball mill is inseparable from the maintenance of the ball mill gear. Today we are straight to the point, and we have a direct look at some important details and maintenance methods for the gear mill maintenance. When the beneficiation ball mill is operating, it must strictly follow the operating procedures. Before the start of the entire ball mill, it must be the same as before the start of other equipment. It is necessary to strictly clean the situation of the energy-saving ball mill barrel, check the lubrication system, and check the lubrication system to ensure high Low pressure oil pump and oil pipeline.
At start-up, these tasks are done to ensure that the high-pressure pump is working properly. This is when the ball mill is actually working. The inspection of the energy-saving ball mill gear should also pay attention to the above-mentioned lubrication measures. Everything is normal to closely observe the working conditions of the gears. If the downtime is more than 4 hours, you should pay attention to slow start slow drive, to give the gear the minimum pressure. This can effectively reduce the load and extend the life of the gear. When daily cleaning of gear oils, keep the lubricity of the energy-saving ball mill gears and pinions. After the spiritual force, the lubricating ability of large and small gears is required to have a good amount of alcohol and prevent excessive wear. If the wear surface is too large, the method of reverse rotation can be used to save the use. Both sides are worn out and must be replaced by gears.

If you are sick and you have to find a doctor, then the energy-saving ball mill is faulty and there are special doctors responsible for it. Zhengzhou Hongtai will provide free mechanical technical guidance to help users solve various problems encountered in production and equipment failures, giving you a reliable and effective production environment. .